When you need stump removal New Braunfels TX homeowners can count on, we grind below grade, haul the chips, and rake the hole level. Our crews handle everything from a single oak stump to a full lot cleared after tree cutting. We have served Comal County since 2015 and know these yards, soils, and HOA rules.
Stump removal New Braunfels TX is the process of eliminating a tree stump and its root flare so the ground can be reused, mowed, or built on. We start by inspecting the stump for rot, regrowth, and buried debris, then set up a stump grinder and cut the wood 6 to 12 inches below grade. Chips get hauled off or left for mulch, and the hole is backfilled with topsoil and raked level.
In New Braunfels, stumps are usually left behind after storm damage, dead tree removal, or a builder clears a lot. Live oak and cedar elm stumps sprout again if they are only cut at the surface, and the limestone under a lot of these yards dulls grinding teeth fast. If you have been searching stump removal near me New Braunfels TX, we can usually look at the job within a few days.
Every stump job includes the grinding, the cleanup, and the backfill. We tell you upfront what is covered so there is no surprise on the invoice. If you want the chips left for mulch or need the hole filled with a specific soil, just say so when we quote.
We cut the stump and root flare 6 to 12 inches below the surrounding grade. That depth is what stops regrowth and lets you plant, sod, or pour over the spot. We make overlapping passes until the wood is gone, not just shaved at the surface.
Grinding produces a surprising pile of chips and dirt. We shovel them out and haul them away unless you ask us to leave them for garden mulch. Leaving them means you get a mound to deal with, so most customers want them gone.
Once the grindings are out, we fill the hole with topsoil and rake it level with the surrounding grade. That gives you a base for sod or seed. We do not leave a crater for you to trip in or fill yourself.
We lay mats or plywood on the access path and contain chips with a tarp or berm. If the gate is tight, we switch to a walk-behind grinder. The goal is to leave your lawn intact except for the spot where the stump was.
Before we leave, we walk the job with you. We point out the finished grade, confirm the stump is gone below the surface, and answer questions about seeding or sod. If something is not right, we fix it before we pack up.
Call 866-332-1549 or send photos of the stump and the access path. We ask about gate width, slope, and whether the stump sits near a fence or foundation. You get a flat price before we schedule, and we can usually be on site within a few days.
On arrival we walk the path with you and flag irrigation lines, cable, and sprinkler heads. If a gate is under 36 inches, we use a smaller grinder or a walk-behind unit. We lay mats on turf and set up so chips stay contained.
We run the stump grinder across the stump in overlapping passes, cutting 6 to 12 inches below the surrounding grade. We watch for rock and metal that can damage teeth, and we stop to clear debris. Expect 20 to 45 minutes of grinding for a typical 18-inch oak stump.
We shovel the grindings out, haul them off unless you want the mulch, and backfill the hole with topsoil. The spot gets raked level and the surrounding turf gets blown clean. You walk the job with us before we pack up.
We point out the finished grade, confirm the stump is gone below the surface, and hand you care instructions. If a sucker pops from a root we missed, call us and we come back. Our work is warrantied, and we do not leave until you sign off.
Call 866-332-1549 or send photos of the stump and the access path. We ask about gate width, slope, and whether the stump sits near a fence or foundation. You get a flat price before we schedule, and we can usually be on site within a few days.
Our primary machine for most residential stumps. It cuts fast through live oak and pecan and has the reach to grind 12 inches below grade without repositioning constantly.
We bring this out for larger stumps and open lots where we need more horsepower and a wider cut. It handles the rocky Comal County ground better than a light-duty unit.
For gates under 36 inches, pool decks, and tight side yards. It fits where a full-size machine cannot go, so you do not have to remove a fence panel to get a stump out.
We use these to cut flush any stump too tall for the grinder and to trim roots that surface around the grind area. Sharp chains and bar oil keep the cuts clean.
When a stump job includes brush or limbs, we chip the material on site and haul the chips. It keeps the debris volume down and the truck bed clear for grindings.
For stumps on slopes or near fences, we use rigging to control how cut pieces fall. It protects structures and keeps the crew out of the drop zone.
A storm took down two live oaks and left 24-inch and 30-inch stumps in the side yard. The homeowner had been cutting suckers for two seasons and the mower had already hit one twice. Access was good but the ground was rocky.
After: We ground both stumps 10 inches below grade, hauled 3 yards of chips, and backfilled with topsoil. The side yard is now one open, mowable surface. The homeowner seeded it that fall and it blended in by spring.
Book this service →
A 22-inch pecan stump sat behind a narrow gate in Gruene. Two other companies said they could not get a machine back there. The homeowner was ready to dig it out by hand, which would have taken a week.
After: We brought the walk-behind grinder through the gate, ground the stump 8 inches below grade, and hauled the chips in buckets. The hole was backfilled and raked level in about three hours. No fence panels were removed.
Book this service →
A property manager had five stumps left from a past clearing, ranging from 14 to 28 inches. They were spread across three yards and the grass had grown over two of them. The mower was hitting one stump every week.
After: We quoted the whole lot at a per-stump discount and finished in one day. All five stumps were ground 8 to 10 inches below grade, chips hauled, and holes backfilled. The mower now runs the full yard without stopping.
Book this service →A stump is a slow problem. It does not fix itself, and ignoring it usually costs more later. Here are the issues we hear about most from homeowners in Comal County.
Ask a pro →We grind the stump and root flare 6 to 12 inches below grade, which removes the tissue that drives regrowth. We also chase the main roots out far enough that you are not fighting suckers in the same spot next spring. One visit, done.
We remove the stump and haul the grindings so there is nothing left to hold water or feed insects. We can also flag any soft spots we see near the foundation so you can get a pest inspection if needed.
Once the stump is ground and the hole is backfilled and raked level, you can mow straight across the spot. No more steering around it, no more blade changes. The yard becomes one open, usable surface again.
We grind the stump out, remove the grindings, and backfill with topsoil that you can compact or amend. That gives you a stable base for a patio, shed, or garden. We can grind to a depth that matches your project plans.
Most single-stump jobs in New Braunfels run $180 to $450 in 2026, depending on diameter, access, and whether you want the chips hauled. A 12-inch stump in an open yard sits at the low end. A 30-inch oak behind a fence with a slope pushes toward the top. Multiple stumps on one property usually get a per-stump discount.
Yes. We grind 6 to 12 inches below the surrounding grade, which removes the root flare and stops most regrowth. Cutting a stump flush at the surface leaves the roots alive and you will see suckers within a season. Grinding below grade is the only way to actually kill it and reuse the ground.
We do. New Braunfels Tree & Land has been grinding stumps in Comal County since 2015, and we cover the 78130, 78131, 78132, and 78135 ZIP codes plus Seguin and Cibolo. Call 866-332-1549 and we can usually quote from photos the same day and schedule within a few days.
Yes, with the right machine and mats. We lay plywood or turf mats on the access path, use a walk-behind grinder when the gate is tight, and contain the chips with a tarp or berm. After grinding we rake and blow the area clean. You will see a bare patch where the stump was, not ruts across the yard.
We are licensed, insured, and have been grinding stumps in Comal County since 2015. Call 866-332-1549 or send a photo of the stump and we will give you a flat price, usually the same day. Most jobs get scheduled within a week.
Get a free quote 8663321549 →Reach out for a free estimate or emergency service. We answer calls 24/7 and respond quickly. Our office is open Monday through Friday, 8 a.m. to 6 p.m., but we're always available for emergencies. Call us at 866-332-1549 or email info@newbraunfelstree&land.com.